Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual page 1297

Chapter 22 Show Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
show islb virtual-target
To display information about iSLB virtual targets, use the show islb virtual-target command.
Syntax Description
name
configured
Defaults None.
Command Modes EXEC mode.
Command History Release
3.0(1)
Usage Guidelines
None.
Examples The following example shows an iSLB target.
switch# show islb virtual-target newtarget0987654321
target: newtarget0987654321
The following example shows all configured iSLB virtual targets.
switch# show islb virtual-target configured
target: testtarget1234567
target: testertarget987654321
OL-18089-01, Cisco MDS NX-OS Release 4.x
show islb virtual-target [name | configured name]
Specifies the iSLB virtual target name. The range is 16 bytes to 223 bytes.
Displays information about configured iSLB virtual targets.
Modification
This command was introduced.
Configured node (iSLB)
No. of initiators permitted: 1
initiator fromtarget1234567890 is permitted
All initiator permit is enabled
Trespass support is disabled
Revert to primary support is
Configured node (iSLB)
No. of initiators permitted: 1
initiator trespass is permitted
All initiator permit is disabled
Trespass support is disabled
Revert to primary support is
Port WWN 10:20:30:40:50:60:70:80
Configured node (iSLB)
No. of initiators permitted: 1
initiator mytargetdevice is permitted
All initiator permit is disabled
disabled
disabled
Cisco MDS 9000 Family Command Reference
show islb virtual-target
22-229