Show Ips Stats Fabric Interface - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Chapter 22 Show Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

show ips stats fabric interface

To display the fabric-related statistics for the given iSCSI or FCIP interface on a Cisco MDS 9000
18/4-Port Multi Service Module IPS linecared, use the show ips stats fabric interface command.
Syntax Description iscsi slot/port
fcip N
Defaults
None.
Command Modes EXEC mode.
Command History Release
3.2(1)
Usage Guidelines
This command also displays information on flow control specific to DPP.
Examples
The following example shows the statistics for iSCSI on the specified interface:
switch# show ips stats fabric interface iscsi1/1
DPP Fabric Statistics for iscsi1/1
OL-18089-01, Cisco MDS NX-OS Release 4.x
show ips stats fabric interface [iscsi slot/port | fcip N]
(Optional) Displays Data Path Processor (DPP) fabric statistics for the iSCSI
interface.
(Optional) Displays DPP fabric statistics for the fcip interface.
Modification
This command was introduced.
Hardware Egress Counters
0 Good, 0 bad protocol, 0 bad header cksum, 0 bad FC CRC
Hardware Ingress Counters
0 Good, 0 protocol error, 0 header checksum error
0 FC CRC error, 0 iSCSI CRC error, 0 parity error
Software Egress Counters
0 good frames, 0 bad header cksum, 0 bad FIFO SOP
0 parity error, 0 FC CRC error, 0 timestamp expired error
0 unregistered port index, 0 unknown internal type
0 RDL ok, 0 RDL drop (too big), 0 RDL ttl_1
0 idle poll count, 146 loopback
0 FCC PQ, 0 FCC EQ, 0 FCC generated
Flow Control: 0 [0], 0 [1], 0 [2], 0 [3]
Software Ingress Counters
0 Good frames, 0 header cksum error, 0 FC CRC error
0 iSCSI CRC error, 0 descriptor SOP error, 0 parity error
0 frames soft queued, 0 current Q, 0 max Q, 0 low memory
0 out of memory drop, 0 queue full drop
0 RDL ok, 0 RDL drop (too big)
show ips stats fabric interface
Cisco MDS 9000 Family Command Reference
22-193