Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual page 1275

Chapter 22 Show Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
show isapi tech-support santap file
To display ISAPI information for troubleshooting, use the show isapi tech-support santap file
command.
Syntax Description name
Defaults None.
Command Modes
Configuration mode.
Command History Release
NX-OS 4.1(1b)
Usage Guidelines SANTap tech support, collected through the above cli, is stored in the line card modflash. It includes
ISAPI tech support and the outputs of 'show debug santap event-history' and 'show santap tech-support'
These two outputs are not present in ISAPI tech support, and are not collected after a dpp crash.
The size of the modflash is limited, close to 60 MB in 4.1(1). If less space remains on modflash than the
size of the output file, an unusable truncated file may get created. To ensure that the SANTap tech
support file gets created in the modflash properly, enough space (at least 20 MB) should be made
available before issuing the cli. Best practice is to copy out a tech support file after collecting the tech
support, and delete it from the modflash.
ISAPI tech support collected through the show isapi tech-support file <filename> gets stored in the line
card log directory.
The size of the log directory is also limited, to 180 MB. This is shared for some other purposes as well.
Again, at least 20 MB should be made available in the log directory before collecting ISAPI tech support,
and the file should be copied out and deleted from the log directory once done.
The following commands may be used for copying and deleting files from the modflash and log
directories on the line card:
'copy log://<module>/<file name> <target fs>' (issued on supervisor module) will copy out isapi tech
support file from /var/log/external.
'copy modflash://<module>-1/<file name> <target fs>' (issued on supervisor module) will copy out
santap-isapi tech support file from the line card modflash.
'clear debug-logfile <filename>' (issued on line card module) will delete logfiles in the line card log
directory.
'delete modflash://<module>-1/<filename>' (issued on supervisor module) will delete logfiles in the line
card modflash.
OL-18089-01, Cisco MDS NX-OS Release 4.x
show isapi tech-support santap file [name]
(Optional) Specifies the name of the file. The file is stored on modflash.
Modification
Added Usage Guidelines.
show isapi tech-support santap file
Cisco MDS 9000 Family Command Reference
22-207