Read-Only - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Chapter 20 R Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

read-only

To configure the read-only attribute in a zone attribute group, use the read-only command in zone
attribute configuration submode. To revert to the default, use the no form of the command.
Syntax Description This command has no other arguments or keywords.
Defaults
Read-write.
Command Modes
Zone attribute configuration submode.
Command History Release
2.0(x)
Usage Guidelines This command only configures the read-only attribute for enhanced zoning. To enable broadcast zoning
for basic mode, use the attribute read-only subcommand after entering zone configuration mode using
the zone name command.
Examples The following example shows how to set the read-only attribute for a zone attribute group.
switch# config terminal
switch(config)# zone-attribute-group name admin-attributes vsan 10
switch(config-attribute-group)# read-only
Related Commands Command
show zone-attribute-group
zone mode enhanced vsan
zone name
zone-attribute-group name
OL-18089-01, Cisco MDS NX-OS Release 4.x
read-only
no read-only
Modification
This command was introduced.
Description
Displays zone attribute group information.
Enables enhanced zoning for a VSAN.
Configures zone attributes.
Configures zone attribute groups.
Cisco MDS 9000 Family Command Reference
read-only
20-19