Pwwn (Sdv Virtual Device Configuration Submode) - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

pwwn (SDV virtual device configuration submode)

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
pwwn (SDV virtual device configuration submode)
To add a pWWN to a virtual device, use the pwwn command in SDV virtual device configuration
submode. To remove a pWWN from a virtual device, usethe no form of the command.
Syntax Description pwwn-name
primary
Defaults None.
Command Modes SDV virtual device configuration submode.
Command History Release
3.1(2)
Usage Guidelines None.
Examples The following example shows how to add a pWWN to a virtual device.
switch# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# sdv virtual-device name sqa2 vsan 1
switch(config-sdv-virt-dev)# pwwn 21:00:00:04:cf:cf:45:40
Related Commands Command
sdv enable
show sdv statistics
Cisco MDS 9000 Family Command Reference
18-48
pwwn pwwn-name [primary]
no pwwn pwwn-name [primary]
Specifies the pWWN of a real device. The format is
hh:hh:hh:hh:hh:hh:hh:hh, where h is a hexadecimal number.
Configures the virtual device as a real device.
Modification
This command was introduced.
Description
Enables or disables SAN device virtualization.
Displays SAN device virtualization statistics.
Chapter 18 P Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x