System Delayed-Traps Timer - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

system delayed-traps timer

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
system delayed-traps timer
To configure the system-delayed trap timeout values, use the system delayed-traps timer command. To
disable the system-delayed trap timeout values, use the no form of the command.
Syntax Description number
Defaults
None.
Command Modes Configuration mode.
Command History Release
NX-OS 4.1(1b)
Usage Guidelines
System delayed traps timer is optional. If the user does not provide the timer value, default value of 4 is
applied.
Examples The following example shows how to configure system-delayed trap values:
switch(config)# system delayed-traps timer 30
switch(config)#
Cisco MDS 9000 Family Command Reference
21-100
system delayed traps-timer {number}
no system delayed traps-timer {number}
Indicates the delayed trap timer in minutes. The range is from 1 to 60.
Modification
This command was introduced.
Chapter 21 S Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x