System Trace - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

system trace

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
system trace
To configure the system trace level, use the system trace command in configuration mode. To disable
this feature, use the no form of the command.
Syntax Description bit-mask
Defaults
None.
Command Modes Configuration mode.
Command History Release
1.0(2)
Usage Guidelines
This command is used for debugging purposes.
Examples
The following example shows how to configure the system trace level.
switch# config terminal
switch(config)# system trace 0xff
Cisco MDS 9000 Family Command Reference
21-128
system trace bit-mask
no system trace
Specifies the bit mask to change the trace level.
Modification
This command was introduced.
Chapter 21 S Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x