Chapter 13 K Command; Keepalive - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

keepalive

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
keepalive
To configure the message keepalive interval for the IKE protocol, use the keepalive command in IKE
configuration submode. To revert to the default, use the no form of the command.
Syntax Description seconds
Defaults 3600 seconds or 1 hour.
Command Modes IKE configuration submode.
Command History Release
2.0(x)
Usage Guidelines The keepalive interface only applies to IKE version 2 tunnels.
To use this command, the IKE protocol must be enabled using the crypto ike enable command.
Examples The following example shows how to configure the keepalive interval:
switch# config terminal
switch(config)# crypto ike domain ipsec
switch(config-ike-ipsec)# keepalive 7200
Related Commands Command
crypto ike domain ipsec
crypto ike enable
show crypto ike domain ipsec Displays IKE information for the IPsec domain.
Cisco MDS 9000 Family Command Reference
13-2
keepalive seconds
no keepalive seconds
Specifies the number of seconds for the keepalive interval. The range is 120
to 86400.
Modification
This command was introduced.
Description
Enters IKE configuration mode.
Enables the IKE protocol.
Chapter 13 K Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x