Ipv6 Enable - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

ipv6 enable

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
ipv6 enable
To enable IPv6 processing and configure an IPv6 link-local address on the interface, use the ipv6 enable
command in interface configuration submode. To disable IPv6 processing and remove the link-local
address, use the no form of the command.
Syntax Description
This command has no arguments or keywords.
Defaults None.
Command Modes Interface configuration submode.
Command History Release
3.0(1)
Usage Guidelines
When you enable IPv6 on an interface, a link local address is automatically assigned. This address is
used for communication on the switch.
Examples The following example enables IPv6 processing on the interface.
switch# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# interface gigabitethernet 2/2
switch(config-if)# ipv6 enable
The following example disables IPv6 processing on the interface.
switch(config-if)# no ipv6 enable
Related Commands ipv6 address
ipv6 nd
ipv6 traffic-filter
show interface
Cisco MDS 9000 Family Command Reference
11-74
ipv6 enable
no ipv6 enable
Modification
This command was introduced.
Configures the IPv6 address and enables IPv6 processing.
Configures IPv6 neighbor discovery commands on the interface.
Configures IPv6 ACLs to filter traffic for packets on the interface.
Displays interface configuration information.
Chapter 11 I Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x