Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual page 1372

show port-channel compatibility-parameters
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
show port-channel compatibility-parameters
To display the PortChannel compatibility parameters, use the show port-channel
compatibility-parameters command.
Syntax Description This command has no arguments or keywords.
Defaults None.
Command Modes
EXEC mode.
Command History Release
NX-OS 4.1(3)
Usage Guidelines None.
Examples The following example shows how to display the PortChannel compatibility parameters:
switch# show port-channel compatibility-parameters
Parameters that have to be consistent across all members in a port-channel.
1. physical port layer
Members must have the same interface type, such as fibre channel, ethernet
or fcip.
2. port mode
Members must have the same port mode configured, either E or AUTO. If they
are configured in AUTO port mode, they have to negotiate E mode when they
come up. If a member negotiates a different mode, it will be suspended.
3. trunk mode
Members must have the same trunk mode configured. If they are configured in
AUTO trunking mode, they have to negotiate the same trunking mode when they
come up. If a member negotiates a different mode, it will be suspended.
4. speed
Members must have the same speed configured. If they are configured in AUTO
speed, they have to negotiate the same speed when they come up. If a member
negotiates a different speed, it will be suspended.
5. MTU
Cisco MDS 9000 Family Command Reference
22-304
show port-channel compatibility-parameters
Modification
This command was introduced.
Chapter 22 Show Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x