Span Session Source Interface - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Chapter 21 S Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

span session source interface

To configure the SPAN traffic in both ingress (rx) and egress (tx) directions, use the span session source
interface command in Configuration mode.
Syntax Description session-id
interface type
Defaults None.
Command Modes
Configuration mode
Command History Release
1.0(x)
3.3(1a)
Usage Guidelines None.
Examples
The following example shows how to configure the SPAN traffic in both ingress and egress directions.
switch#config
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# span session 1
switch(config-span)# source interface fc 1/5 rx
switch(config-span)# source interface fc 1/5 tx
switch(config-span)# destination interface fc 1/5
Related Commands Command
show span session
OL-18089-01, Cisco MDS NX-OS Release 4.x
span session session-id source interface interface type
Specifies the SPAN session ID.
Specifies the destination interface mapped to a Fiber Channel or FC tunnel.
Modification
This command was introduced.
Enabled SPAN traffic in both ingress (rx) and egress (tx) directions for
Generation 2 Fabric Switches.
Description
Displays specific information about a Switched Port Analyzer (SPAN)
session.
span session source interface
Cisco MDS 9000 Family Command Reference
21-63