Port-Channel Persistent - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Chapter 18 P Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

port-channel persistent

To convert an automatically created PortChannel to a persistent PortChannel, use the port-channel
persistent command in EXEC mode.
Syntax Description port-channel number
Defaults None.
Command Modes
EXEC mode.
Command History Release
NX-OS 4.1(3)
2.0(x)
Usage Guidelines The auto mode support is not available after 4.x. Any previously automatically created PortChannel
needs to be made persistent by using the port-channel persistent command. This command needs to be
run on both sides of the auto Port Channel.
Examples The following example shows how to change the properties of an automatically created channel group
to a persistent channel group:
switch# port-channel 10 persistent
Related Commands Command
show interface port-channel Displays PortChannel interface information.
show port-channel
OL-18089-01, Cisco MDS NX-OS Release 4.x
port-channel port-channel number persistent
Specifies the PortChannel number. The range is 1 to 256.
Modification
Added usage guideline.
This command was introduced.
Description
Displays PortChannel information.
Cisco MDS 9000 Family Command Reference
port-channel persistent
18-15