Switch-Priority - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

switch-priority

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
switch-priority
To configure the switch priority with the Call Home function, use the switch-priority command in Call
Home configuration submode. To disable this feature, use the no form of the command.
Syntax Description priority-value
Defaults
None.
Command Modes Call Home configuration submode.
Command History Release
4.1(1b)
1.0(2)
Usage Guidelines
The CallHome switch priority is specific to each switch in the fabric. It is set by the switch administrator
to guide the operations personnel who receive the callHome messages as to which messages should be
serviced first. For example, the switch priority of a trading floor switch may be set higher than that of a
switch in a tape backup network because the trading floor users may not be able to tolerate as much
service interruption as the backup network.
Examples The following example shows how to configure the switch priority in the Call Home configuration:
switch# config terminal
Enter configuration commands, one per line.
switch(config)# callhome
switch(config-callhome)# switch-priority 0
Related Commands Command
callhome
callhome test
show callhome
Cisco MDS 9000 Family Command Reference
21-80
switch-priority {priority-value}
no switch-priority {priority-value}
Specifies the priority level. 0 is the highest priority and 7 the lowest.
Modification
Added usage guidelines.
This command was introduced.
Description
Configures the Call Home function.
Sends a dummy test message to the configured destination(s).
Displays configured Call Home information.
End with CNTL/Z.
OL-18089-01, Cisco MDS NX-OS Release 4.x
Chapter 21 S Commands