Show Islb Vrrp - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Chapter 22 Show Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

show islb vrrp

To display iSLB VRRP load balancing information, use the show islb vrrp command.
Syntax Description assignment
initiator node-name
vr group-number
interface
switch WWN
summary
Defaults None.
Command Modes EXEC mode.
Command History Release
3.0(1)
Usage Guidelines
None.
Examples The following example shows iSLB VRRP interface information.
switch# show islb vrrp interface vr 41
-- Interfaces For Load Balance --
OL-18089-01, Cisco MDS NX-OS Release 4.x
show islb vrrp [assignment [initiator node-name [vr group-number] | vr group-number] |
interface [switch WWN [vr group-number] | vr group-number] | summary [vr group-number]
| vr group-number]
Displays iSLB VRRP initiator to interface assignment.
Displays a specific iSLB initiator's interface assignment. The maximum is
80.
Displays information for a specific VR group. The range is 1 to 255.
Displays iSLB VRRP interface information.
Displays a interface information for a specific switch. The format of WWN
is hh:hh:hh:hh:hh:hh:hh:hh.
Displays iSLB VRRP load balancing summary information.
Modification
This command was introduced.
Interface GigabitEthernet1/1.441
Switch wwn: 20:00:00:0d:ec:02:cb:00
VRRP group id: 41, VRRP IP address: 209.165.200.226
Interface VRRP state: backup
Interface load: 3000
Interface redirection: enabled
Group redirection: enabled
Number of physical IP address: 1
(1) 209.165.200.226
Port vsan: 1
Forwarding mode: store-and-forward
Proxy initiator mode: disabled
iSCSI authentication: CHAP or None
Cisco MDS 9000 Family Command Reference
show islb vrrp
22-231