Show Install All Failure-Reason - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

show install all failure-reason

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
show install all failure-reason
To identify the cause of a nondisruptive software upgrade failure, use the show install all failure-reason
command when prompted by the system.
Syntax Description This command has no arguments or keywords.
Defaults None.
Command Modes
EXEC mode.
Command History Release
3.1(1)
Usage Guidelines If an upgrade failure is due to some other cause, nothing is displayed when you enter the command. This
command displays a valid output only if a service aborts an upgrade and a message instructing you to
issue this command is returned to the CLI.
Examples The following example displays the output during an unsuccessful nondisruptive software upgrade, and
it shows the reason for the failure.
Do you want to continue with the installation (y/n)?
Install is in progress, please wait.
Notifying services about the upgrade.
[#
Please issue "show install all failure-reason" to find the cause of the failure.
Install has failed. Return code 0x401E0066 (request timed out).
Please identify the cause of the failure, and try 'install all' again.
switch# show install all failure-reason
Service: "cfs" failed to respond within the given time period.
switch#
Related Commands Command
show install all status
Cisco MDS 9000 Family Command Reference
22-158
show install all failure-reason
Modification
This command was introduced.
] 0% -- FAIL. Return code 0x401E0066 (request timed out).
Description
Displays the status of an installation or ISSU.
Chapter 22
[n] y
OL-18089-01, Cisco MDS NX-OS Release 4.x
Show Commands