Iscsi Initiator Name - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Cisco mds 9000 family command reference guide - release 4.x (ol-18089-01, february 2009)
Hide thumbs Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
Table of Contents

Advertisement

Chapter 11
I Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

iscsi initiator name

To configure an iSCSI initiator name and change to iSCSI configuration mode, use the iscsi initiator
name command. To revert to factory defaults, use the no form of the command.
Syntax Description
name
Defaults
Disabled.
Command Modes
Configuration mode.
Command History
Release
1.3(2)
Usage Guidelines
Under a circumstance where an iSCSI initiator needs to have a persistent binding to FC WWNs, this
command should be used. Also, an iSCSI initiator can be put into multiple VSANs. An iSCSI host can
become a member of one or more VSANs.
Note
This command is not supported on the Cisco MDS 9124 switch, the Cisco Fabric Switch for HP c-Class
BladeSystem, and the Cisco Fabric Switch for IBM BladeCenter.
Examples
The following example configures an iSCSI initiator using the iSCSI name of the initiator node.
switch# config terminal
Enter configuration commands, one per line.
switch(config)# iscsi initiator name iqn.1987-02.com.cisco.initiator
Related Commands
Command
show iscsi initiator
OL-18089-01, Cisco MDS NX-OS Release 4.x
iscsi initiator name name
no iscsi initiator name name
Modification
This command was introduced.
Description
Displays information about configured iSCSI initiators.
Enters the initiator name to be used. The minimum length is 16
characters and maximum is 223 characters.
End with CNTL/Z.
Cisco MDS 9000 Family Command Reference
iscsi initiator name
11-93

Advertisement

Table of Contents
loading

Table of Contents