Show Ip Arp - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Chapter 22 Show Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

show ip arp

To display IP neighbors for the system, use the show ip arp command.
Syntax Description
interface
cpp module-number
gigabitethernet slot/port
mgmt
vsan vsan-id
Defaults None.
Command Modes
EXEC mode.
Command History Release
3.0(1)
Usage Guidelines None.
Examples The following example displays IP neighbor information.
switch# show ip arp
IP Address
209.165.200.226 0
209.165.200.227 5
209.165.200.228 11
209.165.200.229 67
209.165.200.230 0
209.165.200.231 0
209.165.200.232 1067
Related Commands Command
show ip interface
show ip traffic
OL-18089-01, Cisco MDS NX-OS Release 4.x
show ip arp [interface {cpp module-number | gigabitethernet slot/port | mgmt | vsan vsan-id}]
Modification
This command was introduced.
Age(min)
Description
Displays IP interface status and configuration information.
Displays IP protocol statistics for the system.
Displays the IP neighbors for a specified interface.
Specifies the virtualization IP over Fibre Channel (IPFC) interface by
control plane processor (CPP) module number. The range is 1 to 6.
Specifies the Gigabit Ethernet interface by slot and port number. The
range is 1 to 6.
Specifies the management interface.
Specifies the IPFC VSAN interface by VSAN ID. The range is 1 to 4093.
Link-layer Addr
0006.d623.4008
0002.b3d9.ba6f
0004.23bd.677b
0000.0c07.ac01
000e.d68f.c3fc
000e.d68f.43fc
00e0.8152.7f8d
Cisco MDS 9000 Family Command Reference
Type Interface
ARPA GigabitEthernet1/1
ARPA GigabitEthernet1/1
ARPA GigabitEthernet1/1
ARPA mgmt0
ARPA mgmt0
ARPA mgmt0
ARPA mgmt0
show ip arp
22-179