System Delayed-Traps Enable Mode - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Chapter 21 S Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

system delayed-traps enable mode

To configure the system-delayed trap state, use the system delayed-traps enable mode command. To
disable the system-delayed trap state, use the no form of the command.
Syntax Description FX
Defaults None.
Command Modes Configuration mode.
Command History Release
NX-OS 4.1(1b)
Usage Guidelines None.
Examples The following example shows how to configure the system-delayed trap state:
switch(config)# system delayed-traps enable mode FX
switch(config)#
OL-18089-01, Cisco MDS NX-OS Release 4.x
system delayed-traps enable mode {FX}
no system delayed-traps enable mode {FX}
Enables or disables delayed traps for operationally up FX (F/FX) mode
interfaces.
Modification
This command was introduced.
system delayed-traps enable mode
Cisco MDS 9000 Family Command Reference
21-99