Switchport Ingress-Rate - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

switchport ingress-rate

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
switchport ingress-rate
To configure the port rate limit for a specified interface, use the switchport ingress-rate command in
interface configuration mode. Use the no form of the command to delete the configured switch port
information.
Syntax Description
limit
Defaults Disabled.
Command Modes Interface configuration submode.
Command History Release
1.3(1)
Usage Guidelines Access this command from the
following conditions are true:
•
•
Examples The following example configures the ingress rate limit on a Fibre Channel interface.
switch# config terminal
switch(config)# interface fc 2/5
switch(config-if)# switchport ingress-rate 5
Related Commands Command
show interface fc
Cisco MDS 9000 Family Command Reference
21-92
switchport ingress-rate limit
no switchport ingress-rate limit
Specifies the ingress rate limit as a percentage. The range is 1 to 100.
Modification
This command was introduced.
The QoS feature is enabled using the qos enable command.
The command is issued in a Cisco MDS 9100 series switch.
Description
Displays an interface configuration for a specified Fibre Channel interface.
submode. This command is only available if the
switch(config-if)#
Chapter 21 S Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x