Switch Priority - Cisco WLC 5700 Series Command Reference Manual

High Availability Commands

switch priority

To change the stack member priority value, use the switch priority command in mode on the .
switch stack-member-number priority new-priority-value
Syntax Description
stack-member-number
new-priority-value
Command Default
The default priority value is 1.
Command Modes
Command History
Release
Cisco IOS XE 3.2SE
Usage Guidelines
The new priority value is a factor when a new is elected. When you change the priority value the is not
changed immediately.
Examples This example shows how to change the priority value of stack member 6 to 8:
Controller switch 6 priority 8
Changing the Switch Priority of Switch Number 6 to 8
Do you want to continue?[confirm]
OL-32317-01
Current stack member number. The range is 1 to 2.
New stack member priority value. The range is 1 to 15.
The stack member with higher priority value receives high priority in
the stack.
Modification
This command was introduced.
High Availability Command Reference, Cisco IOS XE Release 3E (Cisco WLC 5700 Series)
switch priority
37