Enable; Encryption - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

encryption

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
encryption
To configure an encryption algorithm for an IKE protocol policy, use the encryption command. To revert
to the default, use the no form of the command.
Syntax Description 3des
aes
des
Defaults
3des
Command Modes
IKE policy configuration submode.
Command History Release
2.0(x)
Usage Guidelines To use this command, the IKE protocol must be enabled using the crypto ike enable command.
Examples
The following example shows how to configure the encryption algorithm for the IKE protocol:
switch# config terminal
switch(config)# crypto ike domain ipsec
switch(config-ike-ipsec)# policy 1
switch(config-ike-ipsec-policy)# encryption 3des
Related Commands Command
crypto ike domain ipsec
crypto ike enable
policy
show crypto ike domain ipsec Displays IKE information for the IPsec domain.
Cisco MDS 9000 Family Command Reference
7-4
encryption {3des | aes | des}
no encryption
168-bit DES (3DES)
128-bit AES-CBC
56-bit DES-CBS
Modification
This command was introduced.
Description
Enters IKE configuration mode.
Enables the IKE protocol.
Configures IKE policy parameters.
Chapter 7 E Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x