Show Cdp - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

show cdp

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
show cdp
To display CDP parameters configured globally or for a specific interface, use the show cdp command.
Syntax Description all
entry
all
name cdp-name
global
gigabitethernet
slot/port
mgmt 0
neighbors
detail
interface
traffic
Defaults
None.
Command Modes
EXEC mode.
Command History Release
1.1(1)
Usage Guidelines This command is allowed only on the active supervisor module in the Cisco MDS 9500 Series.
Examples
The following example displays all CDP capable interfaces and parameters:
switch# show cdp all
GigabitEthernet4/1 is up
GigabitEthernet4/8 is down
Cisco MDS 9000 Family Command Reference
22-18
show cdp {all | entry [all | name cdp-name] | global | interface [gigabitethernet slot/port |
mgmt 0] | neighbors [detail | interface {gigabitethernet slot/port | mgmt 0}] | traffic
interface [gigabitethernet slot/port | mgmt 0]}
Displays all enabled CDP interfaces.
Displays CDP database entries.
Displays all CDP entries in the database
Displays CDP entries that match a specified name. Maximum length is 256
characters.
Displays global CDP parameters.
Specifies the Gigabit Ethernet interface at the slot number and port number
separated by a slash (/).
Specifies the Ethernet management interface.
Displays all CDP neighbors.
Displays detailed information for all CDP neighbors
Displays CDP information for neighbors on a specified interface.
Displays CDP traffic statistics for an interface.
Modification
This command was introduced.
CDP enabled on interface
Sending CDP packets every 60 seconds
Holdtime is 180 seconds
CDP enabled on interface
Sending CDP packets every 60 seconds
Holdtime is 180 seconds
Chapter 22 Show Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x