Show Interface - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

show interface

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
show interface
You can check the status of an interface at any time by using the show interface command.
Syntax Description interface-range
bbcredit
brief
capabilities
counters
description
transceiver
calibrations
details
trunk vsan
vsan-id
Defaults
Displays information for all interfaces on the switch.
Command Modes EXEC
Command History Release
1.0(2)
1.3(1)
3.0(1)
3.1(2)
NX-OS 4.1(1b)
NX-OS 4.1(1b)
Usage Guidelines You can specify a range of interfaces by issuing a command with the following example format:
interface fc1/1 - 5 , fc2/5 - 7
The spaces are required before and after the dash ( - ) and before and after the comma ( , ).
The show interface interface-type slot/port transceiver command can only be issued on a switch in the
Cisco MDS 9100 Series if the SFP is present.
Table 22-5
Cisco MDS 9000 Family Command Reference
22-164
show interface [interface-range] [bbcredit | brief | capabilities | counters [brief] | description |
transceiver [calibrations | details] | trunk vsan [vsan-id]]
Displays the type of interface.
Displays buffer-to-buffer credit information.
Displays brief information.
Displays hardware port capabilities for a specified interface.
Displays the interface counter information.
Displays the interface description.
Displays the transceiver information for a specified interface.
Displays transceiver calibration information for the specified interface.
Displays detailed transceiver diagnostics information for the specified
interface.
Displays the trunking status of all VSANs.
Displays the trunking status of the specified VSANs. The range is 1 to 4093.
Modification
This command was introduced.
Added the bbcredit keyword and support for cpp and fv interfaces.
Added the capabilities option for Fibre Channel interfaces.
Added the bay | ext interface.
Added the command output for bbcredit information for a switch port.
Added the command output for interface capabilities on a 48 port line card.
lists the interface types supported by the show interface command.
Chapter 22 Show Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x