Flex-Attach Virtual-Pwwn Auto - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

flex-attach virtual-pwwn auto

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
flex-attach virtual-pwwn auto
To enable the FlexAttach virtual port WWN (pWWN) on a specific interface, use the flex-attach
virtual-pwwn auto command. To disable the virtual pWWN, use the no form of the command.
Syntax Description interface auto
interface-list
Defaults
None.
Command Modes Configuration mode
Command History Release
3.3(1a)
Usage Guidelines
The NPV switch assigns the virtual pWWNs to the interface on which FlexAttach is enabled.
Examples
The following example shows how to enable FlexAttach virtual pWWN on a interface.
switch# config
Enter configuration commands, one per line. End with CNTL/Z.
switch#(config)# flex-attach virtual-pwwn auto interface fc 1/1
Related Commands Command
flex-attach
virtual-pwwn
interface
Cisco MDS 9000 Family Command Reference
8-78
flex-attach virtual-pwwn auto [interface auto interface-list]
no flex-attach virtual-pwwn auto [interface auto interface-list]
Specifies the interface list on which FlexAttach virtual pWWN should be
enabled.
Note
Modification
This command was introduced.
Description
Sets the user-specific FlexAttach virtual pWWN.
All interfaces in the interface-list value must be in the shut mode. If
the interface-list value is not provided, then all ports must be in the
shut mode.
Chapter 8 F Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x