Show Line - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

show line

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
show line
To configure a virtual terminal line, use the show line command.
Syntax Description
com1
user-input-string
console
connected
Defaults
None.
Command Modes EXEC mode.
Command History Release
1.2(1)
3.0(1)
Usage Guidelines
None.
Examples
The following example displays output from an MDS switch with a Supervisor-1 module.
switch# show line console
line Console:
Speed: 9600 bauds
Databits: 8 bits per byte
Stopbits: 1 bit(s)
Parity: none
Modem In: Enable
Modem Init-String -
default : ATE0Q1&D2&C1S0=1\015
Statistics: tx:12842 rx:366 Register Bits:RTS|CTS|DTR|DSR|CD|RI
The following example displays output from an MDS switch with a Supervisor-2 module.
switch# show line console
line Console:
Speed: 9600 bauds
Databits: 8 bits per byte
Stopbits: 1 bit(s)
Parity: none
Modem In: Enable
Modem Init-String -
default : ATE0Q0V1&D0&C0S0=1\015
Statistics: tx:12842 rx:366 Register Bits:RTS|CTS|DTR|DSR|CD|RI
Cisco MDS 9000 Family Command Reference
22-254
show line [com1 [user-input-string] | console [connected | user-input-string]]
Displays aux line configuration.
Displays the user-input initial string.
Displays console line configuration.
Displays the physical connection status.
Modification
This command was introduced.
Modified examples for Supervisor-1 and Supervisor-2 modules.
Chapter 22 Show Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x