Pwwn (Dpvm Database Configuration Submode) - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

pwwn (DPVM database configuration submode)

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
pwwn (DPVM database configuration submode)
To add a device to a dynamic port VSAN membership (DPVM) database using the pWWN, use the
pwwn command in DPVM database configuration submode. To remove a device from a DPVM
database using the pWWN, use the no form of the command.
Syntax Description
pwwn-id
vsan vsan-id
Defaults None.
Command Modes
DPVM database configuration submode.
Command History Release
2.0(x)
Usage Guidelines To use this command, DPVM must be enabled using the dpvm enable command.
Examples The following example shows how to add an entry to the DPVM database.
switch# config terminal
switch(config)# dpvm database
switch(config-dpvm-db)# pwwn 11:22:33:44:55:66:77:88 vsan 1
The following example shows how to delete an entry from the DPVM database.
switch(config-dpvm-db)# no pwwn 11:22:33:44:55:66:77:88 vsan 1
Related Commands Command
dpvm database
show dpvm
Cisco MDS 9000 Family Command Reference
18-46
pwwn pwwn-id vsan vsan-id
no pwwn pwwn-id vsan vsan-id
Specifies the port WWN ID. The format is hh:hh:hh:hh:hh:hh:hh, where h
is a hexadecimal number.
Specifies the VSAN ID. The range is 1 to 4093.
Modification
This command was introduced.
Description
Configures the DPVM database.
Displays DPVM database information.
Chapter 18 P Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x