System Default Zone Distribute Full - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

system default zone distribute full

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
system default zone distribute full
To configure default values for distribution to a zone set, use the system default zone distribute full
command in configuration mode. To revert to the defaults, use the no form of the command.
Syntax Description This command has no arguments or keywords.
Defaults
Distribution to active zone sets only.
Command Modes
Configuration mode.
Command History Release
3.0(1)
Usage Guidelines This command distributes the default values for the default zone to all VSANs. The default values are
used when you initially create a VSAN and it becomes active. If you do not want to use the default
values, use the zoneset distribute full vsan command to distribute the operational values for the default
zone.
The system default zone distribute full command should only be used in conjunction with VSANs that
have not yet been created; it has no effect on existing VSANs.
Note Because VSAN 1 is the default VSAN and is always present, this command has no effect on it.
Examples
The following example distributes default values to the full zone set.
switch# config terminal
switch(config)# system default zone distribute full
The following example distributes default values to the active zone set only.
switch(config)# no system default zone distribute full
Related Commands Command
zoneset distribute full
vsan
show system default
zone
Cisco MDS 9000 Family Command Reference
21-104
system default zone distribute full
no system default zone distribute full
Modification
This command was introduced.
Description
Distributes the operational values for the default zone to all zone sets.
Displays default values for the default zone.
Chapter 21 S Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x