Debug Ipfc - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

debug ipfc

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
debug ipfc
To enable IP over Fibre Channel (IPFC) debugging, use the debug ipfc command in EXEC mode. To
disable a debug command, use the no form of the command or use the no debug all command to turn
off all debugging.
Syntax Description all
errors
events
info
kernel
Defaults Disabled.
Command Modes
EXEC mode.
Command History Release
1.0(2)
Usage Guidelines None.
Examples The following example displays the system output when the debug ipfc kernel errors command is
issued:
switch# debug ipfc kernel errors
Related Commands Command
no debug all
Cisco MDS 9000 Family Command Reference
6-64
debug ipfc {all | errors | events | info | kernel {errors | events}}
Modification
This command was introduced.
Description
Disables all debugging.
Enables debugging for all IPFC features.
Enables debugging for IPFC error conditions.
Enables debugging for IPFC tx/rx MTS events.
Enables debugging for IPFC information.
Enables debugging for IPFC kernel operations.
Chapter 6 Debug Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x