Show Ivr Virtual-Switch-Wwn - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

show ivr virtual-switch-wwn

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
show ivr virtual-switch-wwn
To display an inter-VSAN routing (IVR) virtual switch WWN, use the show ivr virtual-switch-wwn
command.
Syntax Description native-switch-wwn
switch-wwn
native-vsan vsan-id
Defaults
None.
Command Modes EXEC mode.
Command History Release
3.0(1)
Usage Guidelines
The sWWN of the virtual switch must be present in the fabric binding database of all the VSANs where
the virtual switch is in use. If the sWWN is not in the database, you must add it before attempting to
implement FICON over IVR.
Examples The following example displays an IVR virtual sWNN.
switch# show ivr virtual-switch-wwn native-switch-wwn 20:00:00:0d:ec:00:8c:c0 native-vsan
1
virtual switch wwn : 20:01:00:0d:ec:00:8c:c1
Related Commands Command
show ivr
Cisco MDS 9000 Family Command Reference
22-250
show ivr virtual-switch-wwn native-switch-wwn switch-wwn native-vsan vsan-id
Modification
This command was introduced.
Description
Displays IVR information.
Specifies the sWWN of the native switch. The format is in dotted hex.
Specifies the ID of the native VSAN. The range is 1 to 4093.
Chapter 22 Show Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x