Ipv6 Routing - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Cisco mds 9000 family command reference guide - release 4.x (ol-18089-01, february 2009)
Hide thumbs Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
Table of Contents

Advertisement

Chapter 11
I Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

ipv6 routing

To enable IPv6 unicast routing, use the ipv6 routing command in configuration mode. To disable IPv6
unicast routing, use the no form of the command.
Syntax Description
This command has no arguments or keywords.
Defaults
None.
Command Modes
Configuration mode.
Command History
Release
3.0(1)
Usage Guidelines
Before using the ipv6 routing command to configure IPv6 features on a switch, become familiar with
the features of IPv6 and its extended addressing capabilities. In particular, it is important to understand
the different types of IPv6 address formats, the IPv6 address prefix format, and the different IPv6 address
types. For detailed information about IPv6, refer to the Cisco MDS 9000 Family CLI Configuration
Guide.
Examples
The following example enables IPv6 routing.
switch # config terminal
switch(config)# ipv6 routing
The following example disables IPv6 routing.
switch(config)# no ipv6 routing
Related Commands
ipv6 access-list
ipv6 route
show ipv6 access-list
show ipv6 route
show ipv6 routing
OL-18089-01, Cisco MDS NX-OS Release 4.x
ipv6 routing
no ipv6 routing
Modification
This command was introduced.
Configures an IPv6 access control list (ACL) and enters IPv6-ACL
configuration submode.
Configures a static IPv6 route.
Displays a summary of ACLs.
Displays the static IPv6 routes configured on the switch.
Displays the IPv6 unicast routing configured on the switch.
Cisco MDS 9000 Family Command Reference
ipv6 routing
11-79

Advertisement

Table of Contents
loading

Table of Contents