Switchport Owner - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

switchport owner

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
switchport owner
To configure the owner string on the port, use the switchport owner command. To disable this feature,
use the no form of the command.
Syntax Description owner
Defaults
None.
Command Modes Interface Configuration mode.
Command History Release
NX-OS 4.1(3)
Usage Guidelines
None.
Examples
The following example shows how to configure the owner string on the port:
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
Switch (config)# interface fc1/1
Switch (config-if)# switchport owner used_by_fc_admin
switch(config-if)#
The following example shows how to remove the owner string from the port:
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
Switch (config)# interface fc1/1
Switch (config-if)# no switchport owner
Related Commands Command
show interface
Cisco MDS 9000 Family Command Reference
21-94
switchport owner [owner]
no switchport owner
Specifies the owner. The maximum length of the string is 80 characters.
Modification
This command was introduced.
Description
Displays an interface configuration for a specified interface.
Chapter 21 S Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x