ssm enable feature dmm
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
ssm enable feature dmm
To enable DMM, use the ssm enable feature dmm command in configuration mode. To disable DMM,
use the no form of the command.
Syntax Description
force
interface
fc slot/port
module slot
Defaults
Disabled.
Command Modes
Configuration mode.
Command History
Release
3.2(1)
Usage Guidelines
Starting with NX-OS 4.1(1b), DMM must be enabled using the ssm enable feature dmm command
before using the SLD tool.
Examples
The following example shows how to enable DMM on a module:
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# ssm enable feature dmm module 1
The following example shows how to enable DMM on an interface:
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# ssm enable feature dmm interface fc 1/1 - 4
The following example shows how to force a reload on some of the ports on a module:
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# ssm enable feature dmm force interface fc 1/1 - 8, fc 1/13 - 16
Cisco MDS 9000 Family Command Reference
22-74
ssm enable feature dmm {force {interface fc slot/port | module slot} | interface fc slot/port |
module slot}
no ssm enable feature dmm {force {interface fc slot/port | module slot} | interface fc slot/port |
module slot}
Forces a switching module reload.
Specifies the interface.
Specifies the Fiber Channel slot and port numbers.
Specifies the SSM module slot number.
Modification
This command was introduced.
Chapter 22
Show Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x