Operation-Packet-Priority - Cisco Nexus 7000 Series Command Reference Manual

operation-packet-priority

operation-packet-priority
To specify the packet priority in a Cisco NX-OS IP Service Level Agreements (SLAs) operation
template, use the operation-packet priority command. To return to the default value, use the no form
of this command.
Syntax Description
normal
high
Command Default Packet priority is normal.
Command Modes UDP jitter configuration (config-ip-sla-jitter)
Command History Release
6.1(1)
Usage Guidelines Increasing the packet priority of an IP SLAs operation can reduce the delay time for the packets in the
queue. This command is supported by the IP SLAs User Datagram Protocol (UDP) jitter operation only.
This command does not require a license.
Examples The following example shows how to enable microsecond precision, configure the Network Time
Protocol (NTP) synchronization offset tolerance to 10 percent, and set the packet priority to high for an
IP SLAs UDP jitter operation:
switch# ip sla configuration
switch(config)# ip sla 1
switch(config-ip-sla)# udp-jitter 205.199.199.2 dest-port 9006
switch(config-ip-sla-jitter)# clock-tolerance ntp oneway percent 10
switch(config-ip-sla-jitter)# operation-packet-priority high
%This configuration allowed only on microsecond precision probe
switch(config-ip-sla-jitter)# ip sla schedule 1 life forever start-time after 00:00:06
switch(config)#
Related Commands Command
show ip sla auto group Displays the configuration including default values of IP SLAs auto-measure
Cisco Nexus 7000 Series NX-OS IP Service Level Agreements (SLAs) Command Reference
1-30
operation-packet-priority {normal | high}
no operation-packet-priority
Specifies that the packet priority is normal.
Specifies that the packet priority is high.
Modification
This command was introduced.
Description
groups.
Chapter 1 Cisco Nexus 7000 Series IP SLAs Commands
OL-27555-03