Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual page 1374

show port-channel compatibility-parameters
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
19. FC receive buffer size
Members must have the same fc receive buffer size. If the configured
receive buffer size is not compatible with the port capability then the
port will be error disabled
20. IP ACLs
Members must not have IP ACLs configured individually on them. This only
applies to ethernet port-channel.
21. sub interfaces
Members must not have sub-interfaces.
22. Duplex Mode
Members must have same Duplex Mode configured.
23. Ethernet Layer
Members must have same Ethernet Layer (switchport/no-switchport) configured.
24. Span Port
Members cannot be SPAN ports.
25. Storm Control
Members must have same storm-control configured.
26. Flow Control
Members must have same flowctrl configured.
27. Capabilities
Members must have common capabilities.
28. port
Members port VLAN info.
29. port
Members port does not exist.
30. switching port
Members must be switching port, Layer 2.
31. port access VLAN
Members must have the same port access VLAN.
--More--
Cisco MDS 9000 Family Command Reference
22-306
Chapter 22 Show Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x