Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual page 802

move
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
move
To remove a file from the source file and place it in the destination file, use the move command in EXEC
mode.
Syntax Description bootflash:
slot0:
volatile:
directory
filename
Defaults
None.
Command Modes EXEC mode.
Command History Release
1.0(2)
Usage Guidelines
If you do not specify the directory name in the command line, the switch prompts you for it.
Examples
The following example moves the file called samplefile from the slot0 directory to the mystorage
directory:
switch# move slot0:samplefile slot0:mystorage/samplefile
Related Commands Command
dir
mkdir
rmdir
Cisco MDS 9000 Family Command Reference
15-16
move {bootflash: | slot0: | volatile:} [directory/] filename
{bootflash: | slot0: | volatile:} [directory/] filename
Source or destination location for internal bootflash memory.
Source or destination location for the CompactFlash memory or PCMCIA
card.
Source or destination location for volatile memory.
Specifies the name of the directory.
Specifies the name of the file to move or create.
Modification
This command was introduced.
Description
Displays a list of files on a file system.
Creates a directory in the Flash file system.
Removes an existing directory in the Flash file system.
Chapter 15 M Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x