Port-Monitor Name - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Chapter 18 P Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

port-monitor name

To display the counter details of the policy, use the port-monitor name command. To delete port
monitor policy, use the no form of the command.
Syntax Description string
Defaults
None.
Command Modes Configuration mode.
Command History Release
4.1(1b)
Usage Guidelines
None.
Examples
The following example shows how to create a cisco policy name and to assign the default value:
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# port-monitor name cisco
switch(config-port-monitor)#
switch(config-port-monitor)# do show port-monitor cisco
Policy Name : cisco Status : Not Active
Port type : All Ports
Counter Threshold Interval Rising Threshold Falling Threshold Stat
------- --------- -------- ---------------- ------------------ ----
Link Loss Delta 60 5 1 Active
Sync Loss Delta 60 5 1 Active
Protocol Error Delta 60 1 0 Active
Signal Loss Delta 60 5 1 Active
Invalid Words Delta 60 1 0 Active
Invalid CRC's Delta 60 5 1 Active
RX Performance Delta 60 2147483648 524288000 Active
TX Performance Delta 60 2147483648 524288000 Active
State Change Delta 60 1 0 Active
-----------------------------------------------------------------------------
switch(config-port-monitor)#
Related Commands Command
show port-monitor
OL-18089-01, Cisco MDS NX-OS Release 4.x
port-monitor name [string]
no port-monitor name [string]
Displays the policy name.
Modification
This command was introduced.
Description
Displays all port monitor policies.
Cisco MDS 9000 Family Command Reference
port-monitor name
18-19