Storage (Dmm Job Configuration Submode) - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

storage (DMM job configuration submode)

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
storage (DMM job configuration submode)
To add a storage port to a DMM job, use the storage command in DMM job configuration submode.
Syntax Description
vsan vsan-id
pwwn port-wwn
existing
new
Defaults None.
Command Modes DMM job configuration submode.
Command History Release
3.2(1)
Usage Guidelines None.
Examples The following example shows how to add storage information to a DMM job:
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# dmm module 3 job 1 create
Started New DMM Job Configuration.
Do not exit sub-mode until configuration is complete and committed
switch(config-dmm-job)# storage vsan 3 pwwn 1d:22:3a:21:3c:44:3b:51 existing
switch(config-dmm-job)#
Related Commands Command
show dmm ip-peer
show dmm srvr-vt-login
Cisco MDS 9000 Family Command Reference
22-76
storage vsan vsan-id pwwn port-wwn {existing | new}
Specifies the VSAN ID. The range is 1 to 4093.
Specifies the world-wide name of the storage port. The format is
hh:hh:hh:hh:hh:hh:hh:hh, where h is a hexadecimal number.
Specifies a port on the existing storage.
Specifies a port on the new storage.
Modification
This command was introduced.
Description
Displays job information.
Enables DMM.
Chapter 22 Show Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x