Address - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

address

To set the tunnel endpoint address:
Syntax
address serverAddress
no address
To configure RIP:
[ no ] address { ipAddress | unnumbered interfaceType interfaceSpecifier }
To configure NAT address pool ranges:
[ no ] address startIpAddress endIpAddress
Command introduced before JUNOSe Release 7.1.0.
Release Information
From Domain Map Tunnel Configuration mode, sets the tunnel endpoint address of
Description
an L2TP tunnel. The no version removes the address of the tunnel.
From Tunnel Group Tunnel Configuration mode, sets the tunnel endpoint address
of an L2TP tunnel. The no version removes the address of the tunnel.
From Interface Configuration or Subinterface Configuration mode, configures RIP to
run on the interface specified by the IP address or on an unnumbered interface. Uses
the default values: send version is RIP version 1, receive version is RIP version 1 and
version 2, authentication is not enabled. The no version deletes the RIP interface.
Use the address commands to configure RIP attributes on the network.
From IP NAT Pool Configuration mode, configures NAT IP address pool ranges. The
no version removes the range from the current NAT address pool.
Options
Address Family Configuration (RIP), Domain Map Tunnel Configuration, IP NAT Pool
Mode
Configuration, Router Configuration (RIP), Tunnel Group Tunnel Configuration
serverAddress IP address of the LNS endpoint
ipAddress Address of IP interface where RIP will be run
unnumbered Specifies that RIP will be run on an unnumbered interface
interfaceType Interface type; see "Interface Types and Specifiers" on page 5
interfaceSpecifier—Particular interface; format varies according to interface
type; see Interface Types and Specifiers on page 5
startIpAddress Starting IP address (inclusive) of the NAT pool range you are
creating
endIpAddress—Ending IP address (inclusive) of the NAT pool range you are
creating
Chapter 2: A Commands
85
address