Cost - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

JUNOSe 11.0.x Command Reference Guide A to M

cost

cost intfCost
Syntax
no cost
Command introduced before JUNOSe Release 7.1.0.
Release Information
Specifies a cost metric for an OSPF remote-neighbor interface. Used in the calculation
Description
of the SPF routing table. The no version restores the default value.
Options
Remote Neighbor Configuration
Mode
468
cost
intfCost Link-state metric cost; a number in the range 1–65535; default value
is 10 if there is no route to the remote neighbor; otherwise, the default is
calculated based on the bandwidth of the physical interface used to reach the
remote neighbor and the OSPF auto-cost reference bandwidth