Adapter Erase - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

JUNOSe 11.0.x Command Reference Guide A to M

adapter erase

adapter erase adapterSpecifier
Syntax
Command introduced in JUNOSe Release 7.1.0.
Release Information
Erases from NVS the type and configuration of the previous IOA in the specified IOA
Description
bay, and allows you to configure a new IOA. Issue this command before you install
a different type of IOA in an IOA bay. There is no no version.
NOTE: Issuing this command reboots the line module associated with the IOA, but
it does not erase its configuration.
To erase the configuration of the line module and its associated IOAs, issue the slot
erase command.
Options
Global Configuration
Mode
84
adapter erase
adapterSpecifier Particular IOA in the format slot/adapter:
slot Number of the chassis slot; for E120 routers, in the range 0–5; for
E320 routers, in the range 0–5 or 11–16
adapter Identifier for the IOA within the chassis slot, either 0 or 1, where:
0 indicates that the IOA is installed in the right IOA bay (E120 router)
or the upper IOA bay (E320 router).
1 indicates that the IOA is installed in the left IOA bay (E120 router) or
the lower IOA bay (E320 router).