Ip Extcommunity-List - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

ip extcommunity-list

ip extcommunity-list listName { permit | deny }
Syntax
extendedCommunity [ extendedCommunity ]*
no ip extcommunity-list listName [ { permit | deny }
extendedCommunity [ extendedCommunity ]* ]
Command introduced before JUNOSe Release 7.1.0.
Release Information
Defines an extended-community (extcommunity) list to be referenced in a route
Description
map. The no version deletes the extcommunity.
Options
Global Configuration
Mode
listName Name of the extended-community list
permit Permits membership in the extended community for matching
conditions
deny Denies membership in the extended community for matching conditions
extendedCommunity Extended community specified in the format:
{rt | soo } { ASN:nn | ipAddress:nn }
rt Specifies a route-target community; consists of one or more routers that
can receive a set of routes advertised by BGP that carry the
extended-community attribute
soo Specifies a Site-of-Origin community; consists of one or more routers
that injects a set of routes into BGP that carry the extended-community
attribute
ASN:nn—Identifies the extended community by a 16-bit autonomous system
number followed by a 32-bit integer
ipAddress:nn Identifies the extended community identified by an IP address
followed by a 16-bit integer
* Indicates that one or more parameters can be repeated multiple times in a
list in the command line
Chapter 10: I Commands
779
ip extcommunity-list