Area Default-Cost - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

area default-cost

area { areaId | areaIdInt } default-cost defaultCost
Syntax
no area { areaId | areaIdInt } default-cost
Command introduced before JUNOSe Release 7.1.0.
Release Information
Specifies a cost for the default summary route sent into a stub area. A stub area is
Description
an OSPF area that carries a default route, intra-area routes, and interarea routes, but
does not carry external routes. You cannot configure virtual links across a stub area.
Stub areas cannot contain an AS boundary router. The no version removes the
configured default route cost.
Options
Router Configuration
Mode
areaId OSPF area ID in IP address format
areaIdInt OSPF area ID as a decimal value 0–4294967295
defaultCost Stub area's advertised external route cost (cost metric); an integer
in the range 0–16777215
Chapter 2: A Commands
127
area default-cost