Ip Dhcp-Local Limit - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

ip dhcp-local limit

ip dhcp-local limit
Syntax
{ atm | ethernet | pos | vlan | interface InterfaceType InterfaceSpecifier } value
no ip dhcp-local limit [ atm | ethernet | pos | vlan
| interface InterfaceType InterfaceSpecifier ]
Command introduced before JUNOSe Release 7.1.0.
Release Information
interface keyword and interfaceType and interfaceSpecifier variables added in JUNOSe
Release 7.1.0.
pos keyword added in JUNOSe Release 10.0.0.
Specifies the maximum number of IP addresses that the DHCP local server can supply
Description
to each VPI/VCI, VLAN, Ethernet subnetwork, or POS access interface, or to a particular
interface or subinterface. The no version restores the default address limit value,
48000.
Options
Global Configuration
Mode
atm Specifies the limit for VPIs and VCIs
ethernet Specifies the limit for Ethernet subnets
pos Specifies the limit for POS access interfaces
vlan Specifies the limit for VLANs
interfaceType Interface type; see "Interface Types and Specifiers" on page 5
interfaceSpecifier—Particular interface; format varies according to interface type;
see Interface Types and Specifiers on page 5
value Maximum number of leases, in the range 0–96000; default is 48000
Chapter 10: I Commands
757
ip dhcp-local limit