Clear Bgp Ipv6 - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

JUNOSe 11.0.x Command Reference Guide A to M

clear bgp ipv6

clear bgp ipv6 [ unicast | multicast | vpnv6 | route-target signaling ]
Syntax
[ ipAddress | ipv6Address | peer-group peerGroupName | * ] [ vrf vrfName ]
[ soft [ in | out ] ]
Command introduced before JUNOSe Release 7.1.0.
Release Information
ipv6Address variable added in JUNOSe Release 8.0.0.
route-target signaling keywords added in JUNOSe Release 8.2.0.
Resets the IPv6 BGP session. If the soft option is not used, brings down the underlying
Description
TCP connection and then brings it back up again, causing both peers to resend their
complete BGP routing table. If the soft out option is used, the BGP speaker reapplies
outbound policy and resends all routes to the specified peer(s). If the soft in option
is used, the BGP speaker reapplies inbound policy to the routes received from the
specified peers. This is possible only if soft reconfiguration inbound has been enabled
for the peer or the peer supports the route-refresh capability. There is no no version.
Options
Privileged Exec
Mode
364
clear bgp ipv6
unicast Clears the unicast routing table; the default option
multicast—Clears the multicast routing table
vpnv6—Clears the VPNv6 unicast routing and forwarding table
route-target signaling Clears the route-target membership information
ipAddress IP address of identified BGP neighbor to clear
ipv6Address IPv6 address of identified BGP neighbor to clear
peerGroupName Name of a BGP peer group to clear
* Clears all connections
vrfName Name of a virtual routing and forwarding instance to clear
soft Specifies soft reconfiguration
in Triggers inbound soft reconfiguration
out Triggers outbound soft reconfiguration