Address Authentication Key - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

address authentication key

address { ipAddress | unnumbered interfaceType interfaceSpecifier }
Syntax
authentication key [ 0 | 8 ] authkey
no address [ ipAddress | unnumbered interfaceType interfaceSpecifier ]
authentication key
Command introduced before JUNOSe Release 7.1.0.
Release Information
Specifies the password for text authentication and the key for MD5 authentication.
Description
The no version clears the key for the interface. Supported only in RIP version 2.
Authentication is disabled by default.
Options
Address Family Configuration, Router Configuration
Mode
ipAddress Address of IP interface where RIP will be run
unnumbered Specifies that RIP will be run on an unnumbered interface
interfaceType Interface type; see "Interface Types and Specifiers" on
page 5
interfaceSpecifier—Particular interface; format varies according to interface
type; see Interface Types and Specifiers on page 5
0 Indicates the authKey is entered in unencrypted form (plaintext); this is the
default option
8 Indicates the authKey is entered in encrypted form (ciphertext)
authkey Password sent with RIP messages or the key used to encrypt/decrypt
RIP messages, depending on the authentication mode set for this interface
Chapter 2: A Commands
address authentication key
87