Distance - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

JUNOSe 11.0.x Command Reference Guide A to M

distance

The options available vary depending on your routing protocol context; that is, on
Syntax
whether you are configuring OSPF or RIP.
For OSPF:
[ no ] distance { ospfWeight | ospf { external distExt | inter-area disInter | intra-area
disIntra } [ external distExt | inter-area distInter | intra-area distIntra ]* }
For RIP:
[ no ] distance ripWeight
Command introduced before JUNOSe Release 7.1.0.
Release Information
Defines an administrative distance for RIP or OSPF routes. A distance of 255 prevents
Description
the route from being installed in the routing table. The no version either negates a
command or restores the command's defaults.
Options
Address Family Configuration (RIP), Router Configuration (OSPF or RIP)
Mode
526
distance
distance Weight applied to OSPF routes
ospfWeight Value assigned to OSPF routes that are added to the IP routing table;
a number in the range 1–255
ospf OSPF routes
distExt Distance for external type 5 and type 7 routes; a number in the range
1–255
disInter Distance for interarea routes; a number in the range 1–255
disIntra Distance for intra-area routes; a number in the range 1–255
* Indicates that one or more parameters can be repeated multiple times in a
list in the command line
ripWeight—Administrative distance assigned to RIP routes added to the IP routing
table in the range 0–255; default value is 120