Address Network - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

address network

address { ipAddress | unnumbered interfaceType interfaceSpecifier }
Syntax
network { broadcast | non-broadcast | point-to-point }
no address { ipAddress | unnumbered interfaceType interfaceSpecifier } network
Command introduced before JUNOSe Release 7.1.0.
Release Information
Configures the OSPF network type for the specified interface to something other
Description
than the default for the network medium. The no version restores the default value
for the medium.
NOTE: You must issue the address area command before issuing this command.
Options
Router Configuration
Mode
ipAddress OSPF interface address previously specified with the address
command
unnumbered Indicates that OSPF is running on an unnumbered interface
previously specified with the address command
interfaceType Interface type; see "Interface Types and Specifiers" on page 5
interfaceSpecifier—Particular interface; format varies according to interface
type; see Interface Types and Specifiers on page 5
broadcast Sets network type to broadcast
non-broadcast Sets network type to NBMA
point-to-point Sets network type to point-to-point
Chapter 2: A Commands
99
address network