Discovery-Mode - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

Chapter 5: D Commands

discovery-mode

[ no ] discovery-mode
Syntax
Command introduced in JUNOSe Release 7.2.0.
Release Information
Enables ANCP discovery mode. This mode allows RADIUS software to obtain loop
Description
parameter information from a connected access node. If discovery mode is disabled,
it does not accept topology discovery messages and stops advertising topology
discovery capability. It does not affect any other neighbors. The no version disables
ANCP discovery mode.
L2C Neighbor Configuration
Mode
525
discovery-mode