Table of Contents
Advertisement
JUNOSe 11.0.x Command Reference Guide A to M
framing
framing framingType
Syntax
no framing
Command introduced before JUNOSe Release 7.1.0.
Release Information
Specifies the framing mode used by E3 or T3 interfaces. Available modes vary by
Description
the type of interface. The no version restores the default for that interface.
Options
Controller Configuration
Mode
640
framing
framingType One of the following framing types:
E3 Frame
g751 Default; G.751 compliant frame
g832 G.832 compliant frame
T3
c-bit Default; specifies c-bit parity framing
m23 Specifies M23 multiplexer framing
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 and is the answer not in the manual?
Questions and answers