Address Bfd-Liveness-Detection - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

JUNOSe 11.0.x Command Reference Guide A to M

address bfd-liveness-detection

address { ipAddress | unnumbered interfaceType interfaceSpecifier }
Syntax
bfd-liveness-detection [ minimum-interval minInterval |
[ minimum-receive-interval minRecInterval ]
[ minimum-transmit-interval minTransInterval ] ] [ multiplier multValue ]
no address { ipAddress | unnumbered interfaceType interfaceSpecifier }
bfd-liveness-detection
Command introduced in JUNOSe Release 8.0.0.
Release Information
Enables BFD (bidirectional forwarding detection) on an interface running RIP and
Description
defines BFD values to be negotiated between peers for detection of IP data path
failures. The no version disables BFD on the RIP interface.
Options
Address Family Configuration, Router Configuration
Mode
92
address bfd-liveness-detection
ipAddress Address of IP interface where RIP will be run
unnumbered Specifies that RIP will be run on an unnumbered interface
interfaceType Interface type; see "Interface Types and Specifiers" on page 5
interfaceSpecifier—Particular interface; format varies according to interface
type; see Interface Types and Specifiers on page 5
minInterval Minimum proposed transmit interval and required receive interval
for BFD control packets; has the same effect as configuring the minimum receive
interval and the minimum transmit interval to the same value; number in the
range 100–65535 milliseconds for ES2 4G LM only, the range is 10–65535
milliseconds; default value is 300 milliseconds
minRecInterval Minimum interval at which the local peer must receive BFD
control packets sent by the remote peer; number in the range 100–65535
milliseconds for ES2 4G LM only, the range is 10–65535 milliseconds; default
value is 300 milliseconds
minTransInterval Minimum proposed interval between BFD control packets
sent by the local peer; number in the range 100–65535 milliseconds for ES2
4G LM only, the range is 10–65535 milliseconds; default value is 300 milliseconds
multValue Detection multiplier value that the remote peer router multiplies by
the local peer's negotiated transmit interval to determine the remote peer's BFD
liveness detection interval; equal to the number of BFD packets that can be
missed before the BFD session is declared down; number in the range 1–255;
default value is 3